Common Problems and Solutions of Electric Cigarettes

 

Vape wholesale Bestone OEM：If you can through e-cigarettes to slowly transition from using high-concentration cartridges to low-concentration cartridges, and finally adapt to zero-concentration cartridges, you can truly get rid of the addiction.But in the process of using e-cigarettes, some problems will inevitably arise.The following are these common problems and solutions of e-cigarettes.

 

1.The indicator light is not on and there is no smoke

 

No battery power

 

Please use the matching charger to charge the battery (please refer to the instruction manual for the charging method).A charge takes about 3 hours.When charging, the battery headlight will be on, and the battery can be removed for use after the light is off.The charging time should not exceed 4 hours, otherwise, the battery is easily damaged.

 

The battery is in a protected state

 

The battery will be in a protected state when it is continuously used for more than 15 puffs or one breath is used for too long (more than 5 seconds), and it can be used normally after about 20 seconds.

 

The battery and the atomizer are not tightened

 

Please tighten the battery and the atomizer so that the contact part is in full contact.

 

2.Small amount of smoke

 

In the process of inhaling, the smoke is obviously smaller

The smoke liquid of the cartridge may have been used up, please replace it with a new cartridge, and wait for seven or eight seconds before it can be used normally.

 

Dropped a lot of smoke liquid or just replaced the smoke bomb, the amount of smoke is still very small

 

This is because there is too much smoke, please turn the atomizer upside down and shake out or blow out the excess smoke in the atomizer, and smoke twice.It can be used normally after three times.

 

The user sucked hard, the amount of smoke is still small

This is because of improper use by the user.If the user smokes very hard, the e-cigarette will actually only work for a short time because the stamina cannot keep up, so the amount of smoke will be small.The correct way to use it is to take a light and steady breath in order to enjoy the pleasure of e-cigarettes.

 

3.LED lights often flash

 

During use, the indicator light on the front end of the e-cigarette often flashes inexplicably, which may be due to program settings.Because many e-cigarettes have a humanized design, the indicator will flash when 13-15 puffs (about the number of puffs of a cigarette) are used, or when they are used for a long time (more than 5 seconds).

 

4.The cigarette holder is hot

 

I feel that the cigarette holder is hot when I smoke because of frequent use or insufficient e-liquid.Since the electric cigarette uses a heater to atomize the smoke liquid, the center temperature is as high as 280 degrees, and the atomizer adopts a multi-level heat insulation structure, which generally does not have obvious hotness, but it will be caused by too frequent use or insufficient smoke oil.

 

If a certain amount of heat accumulates, it will feel a little hot, and the user just needs to use it like a normal cigarette.In addition, you will feel hot when the ambient temperature is too high, so minimize the use of e-cigarettes in an overheated environment.

 

5.There is noise when using

 

When in use, the atomizer makes a sound due to the atomization of the smoke liquid.The electric cigarette is instantaneously sublimated into the gas by the liquid-like smoke liquid installed in the heater, which is caused by the violent physical changes in the sublimation process.The sound is normal.

 

6.Smoke liquid inhaled into the mouth

 

When using e-cigarettes, the smoke liquid is sucked into the mouth because there is too much smoke liquid or the method used is improper.There is a device inside the electric cigarette to prevent the liquid from flowing back and prevent the inhalation of the mouth.But because the “smoke” of e-cigarettes is formed by liquid liquefaction.After tens of puffs, because the vaporized liquid meets the cooler inner wall of the cigarette holder, it will liquefy into small droplets attached to the inside of the cigarette holder, and a small amount of liquid may be inhaled when inhaling.This is a normal physical phenomenon.It is enough to install the e-cigarette and flip it out and wipe it dry.

 

In addition, because the user himself adds drops of smoke liquid, it may cause excessive use of smoke liquid to enter the atomizer, which may also inhale the smoke liquid.

 

7.There is a burnt smell

 

If there is a burnt smell during the smoking process, it means that the liquid of the cartridge has been used up.Please replace the cartridge in time.The cartridge can be used normally after seven or eight seconds.

 

If you can choose high-quality e-cigarettes, these problems will not occur frequently.If you want to know more about e-cigarette-related information after reading the above, you can contact us for professional solutions.

 

With excellent R&D technology and high-quality products and services, we have quickly become one of the leading electric cigarettes manufacturers.We have a professional production team and strict quality inspection system, which can carry out comprehensive quality control of the products.At the same time, we will also provide effective solution technology and thoughtful one-stop service according to customer needs.If you want to buy our high-quality e-cigarettes, please contact us immediately!

 

Shenzhen Bestone Technology Co., Ltd. is a global leader in offering vaping OEM/ODM solutions with cutting-edge R&D technology, massive manufacturing capacity, wide range of product’s portfolio and diverse client base.All our products are ISO9001:2000, RoHS, CE, FDA, PSE, UL, and SGS certified.With a decade of OEM/ODM experience for top vaping brands, BESTONE has developed unique heating technology as well as structure, material and design solution to revolutionize the e-cig industry.